How to Install a Vigos Kitchen Faucet
Vigos kitchen faucets are engineered for straightforward DIY installation. Most homeowners can complete the process in 30–60 minutes with basic tools — no professional plumber required. This guide covers installation for Vigos pull-down and pull-out kitchen faucet models.
What You'll Need
- Adjustable wrench or basin wrench
- Plumber's tape (Teflon tape)
- Bucket or towel
- Flashlight
- All hardware included in the Vigos box
Step-by-Step Installation
Step 1: Shut Off the Water Supply
Turn off the hot and cold water supply valves under the sink. Turn on the existing faucet to release any remaining pressure in the lines.
Step 2: Remove the Old Faucet
Disconnect the supply lines from the old faucet using an adjustable wrench. Remove the mounting nut beneath the sink and lift the old faucet out. Clean the sink surface around the mounting hole.
Step 3: Feed the Vigos Faucet Through the Mounting Hole
Thread the Vigos faucet's supply lines and spray hose down through the sink's mounting hole. Vigos pull-down models include a pre-attached hose — feed it through carefully to avoid kinking.
Step 4: Secure the Mounting Hardware
From beneath the sink, slide the mounting bracket and deck plate (if included) onto the supply lines. Hand-tighten the mounting nut, then use a basin wrench to snug it firmly. Do not overtighten — Vigos uses brass fittings that can crack under excessive torque.
Step 5: Connect the Supply Lines
Wrap the supply line threads with plumber's tape, then connect the hot and cold lines to the corresponding shut-off valves. Hand-tighten first, then give a quarter-turn with a wrench.
Step 6: Connect the Spray Hose Weight
Attach the counterweight to the spray hose as shown in the Vigos instruction manual. This keeps the hose retracted properly and ensures the magnetic docking head snaps back into place after use.
Step 7: Turn On the Water and Test
Slowly open the supply valves and check all connections for leaks. Run both hot and cold water through the Vigos faucet for 2–3 minutes. Test the spray head in both stream and spray modes. If you notice any drips, tighten the affected connection slightly.
Vigos Installation Tips
- Check hole size first: Vigos faucets require a standard 1-3/8" to 1-3/4" mounting hole.
- Use the included hardware: Vigos ships all necessary mounting hardware — avoid substituting third-party parts.
- Register your warranty: After installation, register your Vigos faucet at vigo-industries.com to activate the limited lifetime warranty.